Line for the production
of WOOD PELLETS
120, 300-400, 500-600 kg/h.
Metalorad doo Valjevo
manufactures complete pellet production lines for wood.
Depending on your raw material sources—whether it is wood shavings from carpentry shops, sawmills, or if you plan to grind wood—this will determine the equipment you need to acquire.
Machines and equipment required for the production of pellets:
U poslednjih desetak godina od kada je pelet od drveta našao sve veću primenu kao energent za grejanje sve više ljudi se opredeljuje za proizvodnju peleta od drveta.
The way in which the pellet is produced is as follows:
Sawdust obtained from wood processing or ground from wood logs in chippers contains moisture that must be reduced to an appropriate level (10-14%) in order to pelletize successfully.
The material obtained from the chipper is then transferred through a mixer to a hammer mill, where it is ground to a specific granulation. It is subsequently conveyed via screw conveyors to the dryer for moisture reduction.
Zatim ide sve ostalo kao i pre 2 ,3,4,5.
The material obtained from the chipper is then transferred through a mixer to a hammer mill, where it is ground to a specific granulation. It is subsequently conveyed via screw conveyors to the dryer for moisture reduction.
The material is dried in a dryer to the appropriate moisture percentage, using thermal energy from a boiler, which is usually fueled by solid fuel.
The dried sawdust is then fed into a pellet mill, where it is pressed to form pellets. These pellets are subsequently transported to a cooler for cooling.
The resulting pellets are then cooled and packaged into PVC bags.
Commands and control are done from one place from one cabinet.
We can enable the line to have PLC-based controls, meaning you will perform and monitor all commands and controls via a computer screen.
The same elements go into all three lines, and the difference is that, for example, a squeezing device (separator) goes into the manure line, but it does not go into the wood.
The entire line is connected through various mills, conveyors, bins, and other equipment, all of which are also produced by Metalorad d.o.o.
As mentioned earlier, Metalorad d.o.o. produces complete lines for wood pellet production, including: chippers, hammer mills, dryers, mixers, bins, coolers, various conveyors, vibrating screens, sealers, and control panels.
If you decide to purchase a complete line or any part of it, you can contact Metalorad d.o.o. from Valjevo, which can provide answers to all your technical and commercial inquiries.
